Cisco OL-15491-01 - Manual (Page 122)

A-122
Cisco Content Services Gateway - 2nd Generation Release 2.0 Installation and Configuration Guide
OL-15491-01
Appendix A CSG2 Command Reference
ip csg radius endpoint
ip csg radius endpoint
To identify the CSG2 as an endpoint for RADIUS Accounting messages, use the ip csg radius endpoint
command in global configuration mode. To remove the endpoint identification, use the no form of this
command.
ip csg radius endpoint [vrf csg-vrf-name] csg-address key [encrypt] secret-string
[vrf sub-vrf-name]
no ip csg radius endpoint [vrf csg-vrf-name] csg-address
Syntax Description vrf csg-vrf-name (Optional) Virtual Routing and Forwarding (VRF) table which the CSG2 IP
address is to use for RADIUS communication.
Note The VRF table name is defined using the vrf definition command in
global configuration mode. VRF table names supported by the CSG2 can
be from 1 to 32 characters long, and can include uppercase or lowercase
letters, numbers, and any special characters.
The CSG2 does not support the use of the word forwarding as a valid
VRF name.
csg-address Specifies the CSG2 IP address.
The CSG2 IP address must be a virtual IP address, and it must be unique (or the
IP address-VRF name combination must be unique, if VRF is configured). The
CSG2 IP address (or the IP address-VRF name combination) must not be
specified in other CSG2 commands, and it must not match any real IP address,
virtual IP address, or alias IP address (or IP address-VRF name combination)
configured on the CSG2.
If you want the CSG2 RADIUS endpoint IP address to be a member of a CSG2
interface subnet, you must configure the CSG2 IP address as follows:
• In non-redundant configurations, you must configure the CSG2 IP address
as a secondary IP address configured on the appropriate interface.
• In redundant configurations, you must configure the CSG2 IP address as a
standby secondary IP address on the appropriate interface.
Note The CSG2 performs radius endpoint processing only on User Datagram
Protocol (UDP) traffic that is destined for the server IP address. The
server IP address cannot be used for any other UDP communication with
the CSG2.
key Specifies a RADIUS key.