Ip (iscsi) – Cisco OL-15491-01 User Manual
Page 44
A-44
Cisco Content Services Gateway - 2nd Generation Release 2.0 Installation and Configuration Guide
OL-15491-01
Appendix A CSG2 Command Reference
ip (iSCSI)
ip (iSCSI)
To specify the IP address of an iSCSI target in the target interface profile on the CSG2, use the ip
command in iSCSI configuration mode. To remove the IP address configuration, use the no form of the
command.
ip ip-address
no ip ip-address
Syntax Description
Command Default
No default behavior or values.
Command Modes
iSCSI configuration
Command History
Usage Guidelines
Only one target can be defined per profile.
Examples
The following example configures an iSCSI target interface profile with the name targetA to a SCSI
target with the IP address 10.0.0.1:
ip iscsi target-profile targetA
name iqn.2002-10.edu.abc.iol.iscsi.draft20-target:1
ip 10.0.0.1
port 3260
session-timeout 120
target-portal 1
Related Commands
ip-address
IP address of the iSCSI target.
Release
Modification
12.4(15)MD
This command was introduced.
Command
Description
Defines the delay interval, in seconds, before draining
packets from the Storage Area Network (SAN) connected to
the Internet Small Computer Systems Interface (iSCSI)
when the Billing Mediation Agent (BMA) becomes active.
Defines the number of packets to be drained from the
Storage Area Network (SAN) connected to the Internet
Small Computer Systems Interface (iSCSI) per drain delay
interval when the Billing Mediation Agent (BMA) becomes
active.