Name (iscsi) – Cisco OL-15491-01 User Manual
Page 207
A-207
Cisco Content Services Gateway - 2nd Generation Release 2.0 Installation and Configuration Guide
OL-15491-01
Appendix A CSG2 Command Reference
name (iSCSI)
name (iSCSI)
To specify the name of an iSCSI target in the target profile on the CSG2, use the name command in
iSCSI configuration mode. To remove the IP address configuration, use the no form of the command.
name target-name
no name target-name
Syntax Description
Command Default
No default behavior or values.
Command Modes
iSCSI configuration
Command History
Examples
The following example configures an iSCSI target interface profile with the name targetA to a SCSI
target named iqn.2002-10.edu.abc.iol.iscsi.draft20-target:1 :
ip iscsi target-profile targetA
name iqn.2002-10.edu.abc.iol.iscsi.draft20-target:1
ip 10.0.0.1
port 3260
session-timeout 120
target-portal 1
Related Commands
target-name
Name of the iSCSI target.
Release
Modification
12.4(15)MD
This command was introduced.
Command
Description
Specifies the IP address of an iSCSI target in the target
interface profile on the CSG2.
Defines the delay interval, in seconds, before draining
packets from the Storage Area Network (SAN) connected to
the Internet Small Computer Systems Interface (iSCSI)
when the Billing Mediation Agent (BMA) becomes active.
Defines the number of packets to be drained from the
Storage Area Network (SAN) connected to the Internet
Small Computer Systems Interface (iSCSI) per drain delay
interval when the Billing Mediation Agent (BMA) becomes
active.
Specifies the Internet Small Computer Systems Interface
(iSCSI) target to be used as backup storage for the CSG2.