Interlogix NS2503-24P/2C User Manual - Manual (Page 88)

NS2503-24P/2C User Manual
88
State Activity
Having the set up the LACP aggregator the tab of Aggregator Setting, you can configure the state activity for the members of
the LACP trunk group by selecting the checkbox beside the state label. When you remove the check mark of the port and
click Apply , the port state activity will change to Passive.
Figure 4-5-7: State Activity of Switch 1 Screenshot
The page includes the following fields:
Object Description
Active: The port automatically sends LACP protocol packets.
Passive:
The port does not send LACP protocol packets automatically, and responds only
if it receives LACP protocol packets from the other device.
A link having two passive LACP nodes will not perform dynamic LACP trunk because both
ports are waiting for an LACP protocol packet from the other device.