Interlogix NS2503-24P/2C User Manual - Manual (Page 181)

NS2503-24P/2C User Manual
181
show poe status
Description:
Show per PoE port information
Command Level
Global Configuration
Syntax:
show poe status [<port-list>]
Parameters:
<port-list> specifies the ports to be set. If not entered, all ports are set.
Example 1:
Switch(config)# show poe status 1
Port Admin Oper
Power
mode
Priority Power Limit[W]
Current
Consumption [W]
Current[mA]
Device
Class
Port1 Enable on 802.3at Low 30.8 0 0 0
Example 2:
Switch(config)# show poe status
Port Admin Oper
Power
mode
Priority Power Limit[W]
Current
Consumption [W]
Current[Ma]
Device
Class
Port1 Enable on 802.3at Low
30.8
0 0 0
Port2 Enable
on 802.3at
Low 30.8
0 0 0
Port3 Enable
on 802.3at
Low 30.8
0 0 3
Port4 Enable on
802.3at
Low 30.8
0 0 0
Port5 Enable on
802.3at
Low 30.8
0
0
0
Port6 Enable on
802.3at
Low 30.8
0
0
0
Port7 Enable on
802.3at
Low 30.8
0
0
0
Port8 Enable on
802.3at
Low 30.8
0
0
0
| | | | | | | | |
Port24 Enable on
802.3at
Low 30.8
0
0
0
Configure PoE Over Temperature Protection
poe temperature-protection enable
Description:
Configure PoE over temperature protection to enable or disable
Command Level
Global Configuration
Syntax:
poe temperature-protection { enable }
Parameters:
<Enable > Enable PoE power budget change automatically by detected PoE unit temperature
<Disable > Disable PoE power budget change automatically
Once enable the “Temperature-protection” function, the PoE power budget reduce up to
300 Watts
.