Interlogix NS2503-24P/2C User Manual - Manual (Page 153)

NS2503-24P/2C User Manual
153
lacp system-priority
Description:
Set LACP system priority.
Syntax:
lacp system-priority <1..65535>
Parameters:
<1..65535> specifies the LACP system priority.
no lacp system-priority
Description:
Set LACP system priority to the default value 32768.
show lacp status
Description:
Show LACP enable/disable status and system priority.
show lacp
Description:
Show LACP information.
Switch(config)# show lacp status
LACP is enabled.
LACP system priority: 32768
show lacp agg
Description:
Show LACP aggregator information.
Syntax:
show lacp agg
Parameters:
specifies the trunk group to be shown.
show lacp port
Description:
Show LACP information by port.
Syntax:
show lacp port
Parameters:
specifies the port to be shown.
If VLAN group exist, all of the members of static trunk group must be in same
VLAN group.