Interlogix NS2503-24P/2C User Manual - Manual (Page 17)

NS2503-24P/2C User Manual
17
 Per 10/100Mbps port, PoE interfaces (Port-1 to Por-24)
LED Color Function
Illuminates : To indicate the link through that port is successfully established.
LNK/ACT Green
Blink: To indicate that the Switch is actively sending or receiving data over that port.
Illuminates : To indicate the port is providing 52V DC in-line power.
PoE In-Use Orange
Off: To indicate the connected device is not a PoE Powered Device (PD).
 Per 10/100/1000Base-T port / SFP interfaces
LED Color Function
Illuminates: To indicate the link through that port is successfully established with speed
1000Mbps.
Blink : To indicate that the Switch is actively sending or receiving data over that port.
1000
LNK/ACT
Green
Off: If 10/100 LNK/ACT LED is light, it indicates that the port is operating at
10Mbps or 100Mbps. If LNK/ACT LED is Off, it indicates that the port is link
down.
Illuminates: To indicate the link through that port is successfully established with speed
10Mbps or 100Mbps.
Blink : To indicate that the Switch is actively sending or receiving data over that port.
10/100
LNK/ACT
Green
Off: If 1000 LNK/ACT LED is ON, it indicates that the port is operating at
1000Mbps.
If 1000 LNK/ACT LED is Off, it indicates that the port is link down.
1. Press the RESET button for 5 seconds to reboot the Managed Switch.
2. Press the RESET button for 10 seconds to restore the Managed Switch back to the factory default
settings. The entire configuration will be reset to default after this function.
3. The 2 Gigabit TP/SFP combo ports are shared with port 25/26 of the Managed Switch. Either of these
ports can operate at the same time.