Interlogix NS2503-24P/2C User Manual - Manual (Page 116)

NS2503-24P/2C User Manual
116
The page includes the following fields:
 IPv4 ACL
Object Description Default Vaule
Group ID 1 ~ 200
Action Permit / Deny.
 Permit: Permit packet cross switch.
 Deny: Drop packet.
Permit
VLAN Any / VID.
 Any: Any VLAN id.
 VID: 1~4094. A certain VLAN id.
Any
Packet Type IPv4 / Non-IPv4 / Binding
 IPv4: Set Ipv4 packet field.
 Non-IPv4: Set non-Ipv4 packet field.
 Binding: Set binding entry.
IPv4
Src IP Address Set this field if Packet Type is IPv4, else ignore.
Any / IP and Mask
 Any: Any IP address.
 IP: A certain IP address.
Mask: ***.***.***.***
* is represent a digit from 0~9,
*** is range from 0 to 255
Notice: This is not subnet mask.
Any
Dst IP Address Set this field if Packet Type is IPv4, else ignore.
Any / IP and Mask
 Any: Any IP address.
 IP: A certain IP address.
Mask: ***.***.***.***
* is represents a digit from 0~9,
*** is range from 0 to 255
Any
IP Fragment Set this field if Packet Type is IPv4, else ignore.
Uncheck / Check
 Uncheck: Not check IP fragment field.
 Check: Check IP fragment field.
Uncheck
L4 Protocol Set this field if Packet Type is IPv4, else ignore.
Any / ICMP(1) / IGMP(2) / TCP(6) / UDP(17) Any
Protocol Set this field if Packet Type is IPv4, else ignore.
0~255.
If protocol not find in L4 Protocol field, you can direct assign
number.
TCP Set this field if Packet Type is IPv4, else ignore.
Any / FTP(21) / HTTP(80) Any
Port Set this field if Packet Type is IPv4, else ignore.
0~65535
If TCP port not find in TCP field, you can direct assign number.
UDP Set this field if Packet Type is IPv4, else ignore.
Any / DHCP(67) / TFTP(69) / NetBios(137) Any
Port Set this field if Packet Type is IPv4, else ignore.
0~65535
If UDP port not find in UDP field, you can direct assign number.
Port Id Source port id, from 1~10, 0 means don’t care. 0
Current List Creates ACL and Binding groups.