beautypg.com

Tos/dscp configuration, Tos/dscp port configuration – Interlogix NS2503-24P/2C User Manual User Manual

Page 134

background image

NS2503-24P/2C User Manual

134

TOS/DSCP Configuration

The TOS/DSCP page provides fields for defining output queue to specific DSCP fields. When TCP/IP’s TOS/DSCP mode is
applied, the Managed Switch recognizes TCP/IP Differentiated Service Codepoint (DSCP) priority information from the DS-field
defined in RFC2474.

Enable TOS/DSCP for traffic classification and then the DSCP to priority mapping column is configurable, as the

Figure 4-15-5

shows:

Figure 4-15-5:

QoS Configuration – TOS Priority Interface Screenshot

The page includes the following fields:

Object

Description

TOS/DSCP

Enable

/ Disable internal traffic class (0~7) to map the corresponding IP DSCP

value.

DSCP

The values of the IP DSCP header field within the incoming packet.
0~63.

Priority

Specify which 802.1p priority to map the corresponding IP DSCP.
The value is 0~7.

Apply:

Press this button for changes to take affect.

Help:

Provide help information of TOS/DSCP Configuration.

TOS/DSCP Port Configuration

Set up IP TOS / DSCP mapping to 802.1p priority when receiving IPv4 packets, this will enable the Managed Switch to allow the
port configuring the QoS Status. This TOS/DSCP Port Configuration page is to configure the IP TOS/DSCP mapping on the port
and display the current port status. The screen in

Figure 4-15-6

appears.