Interlogix NS2503-24P/2C User Manual User Manual
Page 150

NS2503-24P/2C User Manual
150
<port-list> specifies the ports to be set. If not entered, all ports are set.
port jumboframe
Description:
Set port jumbo frame. When port jumbo frame is enable, the port forward jumbo frame packet
Syntax:
port jumboframe
<enable | disable> [<port-list>]
Parameters:
<port-list> specifies the ports to be set. If not entered, all ports are set.
show port status
Description:
Show port status, including port State, Link, Trunking, VLAN, Negotiation, Speed, Duplex, Flow control, Rate control ,Priority,
Security, BSF control.
Switch(config)# show port status
----------------------------------------------------------------------
Port 1 Information
----------------------------------------------------------------------
State: on
Link: down
Trunking: none
VLAN: DEFAULT
Priority: disable
Security: off
----------------------------------------------------------------------
Port 2 Information
----------------------------------------------------------------------
State: on
Link: down
Trunking: none
VLAN: DEFAULT
Priority: disable
Security: off
----------------------------------------------------------------------
Port 3 Information
----------------------------------------------------------------------
State: on
Link: down
--More--
show port statistics
Description:
Show port statistics, including TxGoodPkt, TxBadPkt, RxGoodPkt, RxBadPkt, TxAbort, Collision, and DropPkt.
Parameters:
<port-id> specifies the port to be shown.
Switch(config)# show port statistics
----------------------------------------------------------------------
Port 1 Information