Interlogix NS2503-24P/2C User Manual - Manual (Page 15)

NS2503-24P/2C User Manual
15
INSTALLATION
This section describes the hardware features and installation of the Managed Switch on the desktop or rack mount. For easier
management and control of the Managed Switch, familiarize yourself with its LED indicators, and ports. Front panel illustrations
in this chapter describe the functions of the LED indicators. Before connecting any network device to the Managed Switch,
please read this chapter completely.
Hardware Description
Switch Front Panel
The unit front panel provides a simple interface monitoring the switch. Figure 2-1 shows the front panel of the Managed Switch.
NS2503-24P/2C Front Panel
Figure 2-1: NS2503-24P/2C Front Panel
■ 10/100Mbps TP Interface
Port-1~Port-24: 10/100Base-TX Copper, RJ-45 Twist-Pair: Up to 100 meters.
■ Gigabit TP Interface
Port-25, Port-26: 10/100/1000Base-T Copper, RJ-45 Twist-Pair: up to 100 meters.
■ Gigabit SFP Slots
Port-25, Port-26: 1000Base-SX/LX/BX mini-GBIC slot, SFP (Small Factor Pluggable) transceiver module: From 550 meters
(Multi-mode fiber), up to 10/20/30/40/50/70 kilometers (Single-mode fiber).
■ Console Port
The console port is a DB9, RS-232 male serial port connector. It is an interface for connecting to a terminal directly.
Through the console port, it provides rich diagnostic information including IP Address settings, factory reset, port
management, link status and system settings. Users can use the attached RS-232 cable in the package and connect to the
console port on the device. After the connection, users can run any terminal emulation program (Hyper Terminal, ProComm
Plus, Telix, Winterm, etc.) to enter the startup screen of the device.