Interlogix NS2503-24P/2C User Manual - Manual (Page 20)

NS2503-24P/2C User Manual
20
Rack Mounting
To install the Managed Switch in a 19-inch standard rack, please follows the instructions described below.
Step1:
Place the Managed Switch on a flat surface, with the front panel positioned towards the front side.
Step2: Attach the rack-mount bracket to each side of the Managed Switch with the supplied screws included in the package.
Figure 2-5 shows how to attach brackets to one side of the Managed Switch.
Figure 2-5: Attach brackets to the Managed Switch
You must use the screws supplied with the mounting brackets. Damage caused to the parts
by using incorrect screws would invalidate the warranty.
Step3: Secure the brackets tightly.
Step4: Follow the same steps to attach the second bracket to the opposite side.
Step5: After the brackets are attached to the Managed Switch, use matching screws to securely attach the brackets to the rack,
as shown in
Figure 2-6 .
Figure 2-6: Mounting the Switch in a Rack
Step6: Proceed with the step 4 and step 5 of section 2.2.1. Desktop Installation to connect the network cabling and supply
power to the Managed Switch.