beautypg.com

Per port priority, Mac address configuration – Interlogix NS2503-24P/2C User Manual User Manual

Page 165

background image

NS2503-24P/2C User Manual

165

e.g.

Switch(config)# show qos
QoS configurations:
QoS mode: weighted round robin
Highest weight: 8
Second High weight: 4
Second Low weight: 2
Lowest weight: 1
802.1p priority[0-7]:
Lowest Lowest SecLow SecLow SecHigh SecHigh Highest Highest

Per Port Priority

port priority

Description:

Set port priority.

Syntax:

port priority

[<port-list>]

Parameters:

<port-list> specifies the ports to be set. If not entered, all ports are set.

e.g. port priority disable 1-5

MAC Address Configuration

clear mac-address-table

Description:

Clear all dynamic MAC address table entries.

mac-address-table static

Description:

Set static unicast or multicast MAC address. If multicast MAC address (address beginning with 01:00:5E) is supplied, the last
parameter must be port-list. Otherwise, it must be port-id.

Syntax:

mac-address-table static

<mac-addr> <vlan-id> <port-id | port-list>

no mac-address-table static mac-addr

Description:

Delete static unicast or multicast MAC address table entries.

Syntax:

no mac-address-table static mac-addr

<vlan-id>

show mac-address-table

Description:

Display MAC address table entries.

Switch(config)# show mac-address-table
MAC Address | VLAN | Type | Source
------------------------------+--------+--------------+------------------------------
00:08:B6:00:06:90 | 1 | Dynamic |9
00:40:63:00:65:30 | 1 | Dynamic | Trk1