Brother 875 MC - Manual (Page 119)

Remote control commands
98 Change Answer Mode
1 MSG CTR
Detail Operation
2 F/T
3 AUTO
90 Exit
If you hear one long beep, you can change the answer mode. If you
hear three short beeps, you can not change it. (ex. There is no MSG
CTR OGM when you want to change to MSG CTR mode.)
After a long beep, you can exit remote control.
Retrieving the Memory Status List and Fax Messages Remotely
From a remote fax machine, you can retrieve your Memory Status List to see if you have any
stored fax messages in the memory. Then you can retrieve all or only specified fax messages that
are on the list.
1. Pick up the handset of a remote touch tone fax machine.
2. Dial your fax machine’s number.
3. When your fax machine answers with a beep, immediately press your Remote
Access Code (159*).
4. As soon as you hear two ( 2 ) short beeps, press 9 6 1 .
5. When you hear your fax machine through the handset responding with a fax
tone, press START and hold the handset if you want to retrieve fax messages also.
(If you wish to retrieve only the Memory Status List, replace the handset.)
6 . Your remote fax machine will print the Memory Status List. (See page 12-6.)
7. Look at the Memory Status List to see if there are any fax messages you want to
retrieve.
8 . Press 96 2 as soon as you hear two ( 2 ) short beeps.
After 96 2, enter the two-digit message numbers from the Memory Status List
(ex.
01 ) and end by pressing 00 .
ex.) To receive N0,1 and N0.2 messages, press 96 2 01 02 00.
If you want to retrieve all mess ages, simply press 00.
ex.) To retrieve all fax messages, press 96 2 00.
9. When you hear your fax machine through the handset responding with a fax
tone, press START.
10. Replace the handset.
11. Your remote fax machine will print the fax messages.
I
10-23