Brother 875 MC - Manual (Page 118)

Remote Control Commands
You can program and control your fax machine with remote control commands.
Remote control commands Detail Operation
91 Playing voice messages After one long beep, the machine plays ICM, Memo and Voice Alarm.
(Skip back) Press 1 while listening to an ICM, Memo or Voice Alarm message to
play it again. If you press 1 before a message, you will hear the
previous message.
(Skip next) During playing ICM, Memo and Voice Alarm, you can skip to next
message.
9 STOP Playing Stop playing ICM, Memo and Voice Alarm.
92 Record Memo After one long beep, you can record a memo. You can stop recording
by pressing 9.
93 Erase all ICM & Memo Ifyou hear one longbeep, the erase is accepted. Ifyou hear three short
beeps, you can not erase because all voice messages have not been
played, or there is no voice message to erase.
*This code erases all recorded messages, not one by one.
94 Play and Record OGM
in memory
1 Play 1 MSGCTROGM
2 F/T OGM
The machine plays the selected OGM. You can stop playing OGM by
pressing 9.
2 Record 1 MSG CTR OGM
2 F/T OGM
After one long beep, you can record the selected OGM. You will hear
the OGM message played once. You can stop recording the message
by pressing 9.
95 Changing Fax Forwarding
/Paging setting
1 OFF.
2 Fax Forwarding
3 Paging
4 FAX FWD NO.
5 FWD NO. CONFIRM
If you hear one long beep, the change is accepted. If you hear three
short beeps, you can not change it because the conditions (ex.
registering paging number) have not been completed. You can
register your fax forwarding number by using 4. FAX FWD NO (see
page 10-24). Once you have registered the number, the machine will
automatically turn to “FAX FWD:ON”mode. Then receive a Memory
Status List by entering 961 (see page 10-23). After you make sure
that the Fax Foiavarding number you registered is correct in the List,
enter the confirmation command 955. Now the machine will start
Fax Forwarding.
96 Retrieve FAX
1 Memory Status List
2 00 Retrieve all FAX
You must call from a remote fax machine in order to receive a report
or stored fax messages. (See page 10-23.)
2 “MSG No.” 00
Retrieve by MSG
number
3 Erase FAX in the
memory
If you hear one long beep, you can erase fax message from the
memory.
97 Check the receiving status
1 FAX
You can check whether your fax machine has received any FAX or
TAD messages. If yes, you will hear one long beep. Ifno, you will hear
three short beeps.
2 TAD
10-22