AERCO Innovation (G-14-2265 and above) - Manual (Page 117)

Innovation Water Heaters Installation, Operation & Maintenance Manual
CHAPTER 8 – WATER HEATER MANAGEMENT
OMM-0078_0L
AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913
Page 117 of
206
GF-128
Phone: 800-526-0288
PRI: 11/25/2014
Example:
If a Master is enabled and in Standby mode, the C-More display will show as follows:
8.5 BST ALTERNATING STATUS DISPLAYS
Master/Slave Status Displays:
On both WHMS Master and Slave heaters, the following status information will alternate, and be
displayed on the two line VFD display on the front of the C-More.
FAILSAFE ACTIVE – The Slave Failsafe Mode has been activated
All Heaters On – All available heaters are ignited
All Heaters Off – All available heaters are off
Enabling First – The first heater is allowed to ignite and its valve is opened
Enabling Next – The next heater is allowed to ignite and it’s valve is opened
Wtr Htr Inactive – This Slave unit is inactive, its valve is closed and can’t ignite
Wtr Heatr Active – This Slave unit is active, its valve is opened and it can ignite
REMOTE SIG FAULT – Remote signal fault
WHMS FAILSAFE
– WHMS is in Failsafe Mode
Example: If all available heaters are turned off, the C-More display will alternate the display
above (MASTER-STANDBY) with the All Heaters Off status message as follows:
8.6 WHM MENU
The WHM Menu in each C-More can only be viewed when the Unit Type option in the
Configuration Menu is set to Innovation WH. Most of the options in this menu are preset at the
factory and cannot be altered by the user.
A full description of each item appears in section 8.7 – WHM Menu Item Descriptions.
NOTES
Some of the WHM menu items appear only if they are enabled, either in
the WHM Menu or by a specific menu item. For example, item 31, WHM
Header Temp, does not appear unless item 30, MB Head Temp En =
Enable.
In addition to the WHM Menu items listed in Table 8-1, the Setup Menu
contains a Comm Address option which must be entered for each unit to
enable WHM control of the system.
MASTER-STANDBY
8:58am 3/05/14
All Heaters Off
8:58am 3/05/14 Alternating status
message
Alternating status
message