Before requesting service – Panasonic NVSX30EG User Manual
Page 140
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ENGLISH
Before Requesting Service
Power Source
Symptom
Cause
Action
Page-
•Movie Camera does not turn |
on.
►•When using Battery as power source:
Attached Battery is discharged.
•Attach fully charged Battery.
24
•Movie Camera has turned off »»Recording was paused for more than 6
automatically. | minutes.
•Turn Movie Camera off гmd then on again.
46
•Movie Camera quickly turns |k»Condensatk>n has formed inside Movie
off. Camera.
•Wait until condensation has cleared up
(approximately 2-3 hours).
120
Cassette
• Remaining Tape Time i
Indication is not correct.
k»Tape length of inserted cassette is not
correctly selected.
•Select correct tape length.
28
•X-ray inspection was done at
\
airport. Did it affect
cassettes?
k»No, it has no adverse influence.
—
•When playing back stored
cassette, picture is distorted.
<1
^•Cassette may have been magnetized by
other equipment.
•Unfortunately, there is no remedy.
Store cassettes correctly.
118
^•Cassette was stored in unsuitable place.
•Unfortunately, there is no remedy.
Store cassettes correctly.
118
Recording
•Movie Camera is turned on |
but no picture appears in
Finder.
►•Power Save Functions have become
activated.
•Hold Movie Camera in horizontal position.
Or set [POWER SAVE] Switch to [OFF].
70
•Recording does not start f
when pressing Start/Stop
Button.
►•Tab of inserted cassette is broken out.
•Insert cassette with intact tab.
Or cover hole with two layers of adhesive
tape.
30
•Date/Time/Title Indication is |
not displayed in Rnder.
►•Incorrect operation of [DATE/TITLE] and/or
[DISPLAY SELECT] Buttons.
•Press [DATE/TITLE] Button so that
Date/Time/Title Indication appears, and then
press [DISPLAY SELECT] Button until
desired Indication appears.
38,106
•Oatenime Indication is not |
displayed in Finder.
►•Built-in lithium battery is discharged.
•Charge built-in lithium battery.
42
Playback
•When playing back from ^
Movie Camera to connected
TV, no playback picture is
reproduced on TV.
L»[P0WER] Switch of Movie Camera is not
turned out.
•Turn [POWER] Switch out and press
[VCR/CAMERA] Button so that [VCR] Lamp
lights.
56
•When playing back from d
Movie Camera to connected L
TV, playback picture is 1
distorted or contains noise
bars.
►•Tape is loose.
•Tighten tape.
26
►•Video heads are dirty.
•Clean video heads with optional video head
cleaning cassette.
120
1
►•Colour adjustment on TV is not made
properly.
•Adjust colour control on TV.
—
►•Tracking is not adjusted correctly.
•Adjust tracking correctly.
64
-140-