6 2-output settings (), Detection mode for output2, Output settings – KEYENCE FS-N10 Series User Manual
Page 81: Detection mode for output2 -35, Output settings ( )
4
Set
tings
f
o
r
Ad
v
an
ced F
u
nct
ion
s
4-35
- Digital Fiber Sensor FS-N10 Series User's Manual -
4-6
2-output Settings (
)
*
This function is only available for the 2-output type models (FS-N13
/ N14
).
*1 If output 2 is set to
Std
, the DATUM1, DATUM2, area detection, and edge detection
modes are disabled in output 2.
*2 You can select the
USEr
(user reset) or
Auto
(auto reset) resetting methods after
outputting the limit setting under the following restriction:
- If output 1 is set to the DATUM1 mode or DATUM2 mode when
LiMt
is selected,
the detection will be performed with the value prior to DATUM calibration.
- If output 1 is set to the area detection mode or edge detection mode,
LiMt
can-
not be selected with output 2.
Detection Mode for Output2
Refer to page 4-3 "2-output Settings (
)" for setting methods.
Display
Function
Std
(Standard)
*1
Received-light intensity judgment mode (usual mode)
(Default)
LiMt
(Limit)
*2
Limit setting output mode (Output 2 turns on if received
light intensity for output 1 decreases).
"Limit setting output mode" (page 4-36)
ALrt
(Alert)
Warning output mode (Output 2 turns on when an error
occurs).