Cisco 12000/10700 V3.1.1 - Manual (Page 519)

16-17
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 16 MPLS VRF Management
VRF Fault Management
General
The General area displays the following information:
VRF Description—The description of this VRF.
Oper Status—Denotes whether a VRF is operational or not. A VRF is up when at least one interface
associated with the VRF, which interface operation status is up. A VRF is down when:
• There does not exist at least one interface whose interface operation status is up.
• There are no interfaces associated with the VRF.
Route Distinguisher—Displays the route distinguisher for this VRF.
No. of Active Interfaces—The number of VRFs which are active on this node. Total number of interfaces
connected to this VRF with interface operation status = up.
No. of Associated Interfaces—Total number of interfaces connected to this VRF (independent of
interface operation status type).
No. of Max Routes—Denotes maximum number of routes which the device will allow all VRFs jointly
to hold. If this value is set to 0, this indicates that the device is unable to determine the absolute
maximum. In this case, the configured maximum may not actually be allowed by the device.
Mid Route Threshold—Displays mid-level water marker for the number of routes which this VRF may
hold.
High Route Threshold—Displays high-level water marker for the number of routes which this VRF may
hold.
Creation Time—Displays the time at which this VRF entry was created.
Config Last Changed—The value of sysUpTime at the time of the last change of this table entry, which
includes changes of VRF parameters defined in this table or addition or deletion of interfaces associated
with this VRF.
Storage Type—Displays the storage type for this entry.
Performance and Security Tab
The Performance and Security tab (see Figure 16-12 ) displays performance and security details in three
areas, VRF Details, Performance and Security.