Cisco 12000/10700 V3.1.1 - Manual (Page 217)

8-15
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 8 Interface Configuration
POS Interface Configuration
Step 4 Click Save to save your configuration changes.
Step 5 Choose File > Close to close the window.
IP Configuration Window—Detailed Description
The IP Configuration window (see Figure 8-1 ) contains one tab: Generic Parameters
Generic Parameters Tab
The Generic Parameters tab contains a single Generic Parameters area.
Generic Parameters
The Generic Parameters area contains the following fields:
IP Address—IP address for the selected interface.
Subnet Mask—Address mask for the selected interface.
Maximum Transmission Unit—Maximum packet size, in bytes, that the selected interface can handle.
IP Maximum Transmission Unit—Maximum packet size, in bytes, that the selected IP interface can
handle.
Interface State—Choose the interface state to be used from the drop down list.
Cisco Discovery Protocol (CDP)—Enable or disable CDP on the interface. CDP allows a device to
advertise its existence to other devices and receive information about other devices on the same LAN or
on the remote side of a WAN.
IP Multicast Fast Switching—Enable or disable IP Multicast Fast Switching on the interface.
POS Interface Configuration
The POS Interface Configuration window allows you to configure a selected POS Interface.
The POS Interface Configuration section covers the following areas:
• Viewing the POS Interface Configuration Window
• Configuring a POS Interface
• POS Interface Configuration Window—Detailed Description
Viewing the POS Interface Configuration Window
To view the POS Interface Configuration window, proceed as follows:
Step 1 Right-click on a selected POS line card or POS interface, then choose Cisco 12000/10720
Manager>Configuration>POS>Configuration. The POS Interface Configuration window appears.