System log, Viewing the syslog messages window – Cisco 12000/10700 V3.1.1 User Manual
Page 143
4-29
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 4 Managing Chassis
System Log
File—When the config source field or the config destination field is set to network tftp or network rcp,
the configuration filename at the storage file server appears.
RCP User—When the config source field or the config destination field is set to network rcp, the remote
user name appears.
Event History Details
The Event History Details area displays the following information:
Uptime at Last Save—Displays the amount of time the system had been up for, when the running
configuration was last saved (written).
Uptime at Last Change—Displays the amount of time the system had been up from when the running
configuration was last changed.
Note
When the value of the uptime at last change field is greater than the uptime at last save field,
the configuration has been changed, but not saved.
Maximum Table Entries—Maximum number of entries that can be displayed.
Entries Deleted from Table—Number of times the oldest entry was deleted to make room for a new entry.
System Log
The System Log Messages window provides a table of all activity carried out by users via CLI or SNMP
on a device. You can opt to be notified of all user activities through alarm notification, if required.
The System Log section covers the following areas:
•
Viewing the SysLog Messages Window
•
System Log Window—Detailed Description
Viewing the SysLog Messages Window
To view the SysLog Messages window, proceed as follows:
Step 1
Right click on the chassis object and select the Fault>SysLog Messages option. See
for information on which objects allow you to launch the SysLog Messages window. The
SysLog Messages window appears, with the SysLog Messages tab displayed.