Cisco 12000/10700 V3.1.1 User Manual
Page 315
11-29
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 11 Layer 3 QoS
WRED Tx Configuration
Figure 11-13 WRED Tx Configuration Window
Step 2
Choose the Chassis, Module and Interface to apply the CoS queue group to from the list boxes
displayed at the left of the window. More than one Chassis, Module or Interface can be selected at a time.
Step 3
Choose the correct CoS queue group and highlight it in the Available CoS Queue Group list.
Step 4
Choose Apply. If the interfaces are currently being managed (are commissioned), then the CoS queue
group is downloaded to the device and the status in the Associated CoS Queue Group Information area
changes to the name of the applied CoS queue group.
Note
Once the Layer3 QoS object is applied to the interface object, the instance of the layer3 QoS
object is displayed under the interface (to which the Layer QoS is applied) in the Component
Managed views.
Note
If a CoS queue group fails to be applied to an interface the Apply Status area on
the WRED Tx Configuration window (see
) is updated
accordingly.