Cisco 12000/10700 V3.1.1 User Manual
Page 465
15-9
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 15 MPLS Management
Fault Management for MPLS LSR Interfaces
Figure 15-3 MPLS Interface Information Window—Interface Setup Tab
Step 2
Choose a Chassis from the list displayed at the left side of the window.
Step 3
Choose an MPLS Interface/Subinterface from the list displayed in the Select Interface area. For further
details on the information displayed in this window, see the
Window—Detailed Description” section on page 15-9
.
MPLS Interface Information Window—Detailed Description
The MPLS Interface Information window displays four tabs: Interface Setup, MPLS Setup, Interface
Performance, and the MPLS Performance tab.
Interface Setup Tab
The Interface Setup tab (see
) displays a single Select Interface area.
Select Interface
The Select Interface area displays the following information:
MPLS Interface/Subinterface list—Lists all the MPLS enabled interfaces and MPLS enabled
sub-interfaces on the selected chassis.
Operational Status—Displays information about the current operational status of the selected interface
(up or down).
MTU—Displays the size of the largest packet that can be sent/received on the selected interface.