Cisco 12000/10700 V3.1.1 - Manual (Page 498)

15-42
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 15 MPLS Management
Fault Management for MPLS Traffic Engineering
LSP Hops Tab
The LSP Hops tab (see Figure 15-23 ) displays the actual route hops and the computed hops for the
selected chassis. This tabs fields are specific to LSPs.
Note To view ARHop and CHop information for a LSP:
1) Choose LSP in the Select Tunnel Area.
2) Note the ARHopListIndex and CHop List Index, and
3) Choose AR Hop Table and CHop Table with the noted Hop List Index.
The LSP Hops tab displays the Select Tunnel, Actual Route Hop Table, and Computed Hop Table areas.
Figure 15-23 MPLS Tunnel Information Window—LSP Hops Tab
Select Tunnel
The Select Tunnel area displays the following information:
Tunnel Id—Displays the tunnel identification number.
Instance—Displays the tunnel instance of the LSP. It is useful to identify multiple instances of tunnels
for the purposes of backup and parallel tunnels.
Ingress LSR—Displays the source IP address of the LSP.
Egress LSR—Displays the egress LSR IP address.