Mpls ldp entity status window—detailed description – Cisco 12000/10700 V3.1.1 User Manual
Page 475

15-19
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 15 MPLS Management
Fault Management for MPLS LDP
Figure 15-9 MPLS LDP Entity Status Window—Entity Tab
Step 2
Choose a Chassis from the list box displayed at the left of the window. Information on LDP entities is
displayed for the selected chassis.
MPLS LDP Entity Status Window—Detailed Description
The MPLS LDP Entity Status window displays five tabs: Entity, Entity Statistics, General Label Range,
ATM Parameters, ATM Label Range.
Entity Tab
The Entity tab (see
) displays basic information about LDP entities. The Entity tab displays
two areas, General and General LDP Status.
General
The General area displays the following information:
LSR Identifier—The LSRs identifier.
LSR Loop Detection—A indication of whether this Label Switch Router supports loop detection:
•
none—Loop Detection is not supported on this LSR.
•
other—Loop Detection is supported but by a method other than those listed below.
•
hopCount—Loop Detection is supported by Hop Count only.
•
pathVector—Loop Detection is supported by Path Vector only.