Bgp modify window—detailed description, Disabling bgp on a chassis – Cisco 12000/10700 V3.1.1 User Manual

Page 398

14-8

Cisco 12000/10700 v3.1.1 Router Manager User Guide

OL-4455-01

Chapter 14 Routing

BGP Configuration

Step 4

Choose the chassis from the left side of the window.

Step 5

Modify the values of the fields and save the changes.

BGP Modify Window—Detailed Description

The BGP Modify window displays the following:

Local AS—The Autonomous System number in the router.

BGP Identifier—Used to configure the Router Identifier for the BGP speaking router.

Note

Peering sessions are reset if the router ID is changed.

BGP Synchronization—This is used to Enable or Disable BGP synchronization with Interior Gateway
Protocol (IGP).

BGP Auto-Summary—This is used to Enable or Disable Automatic network number summarization for
BGP

BGP Log Neighbor-Changes—This is used to set logging of BGP neighbor resets. This value can be set
to “Yes” or “No”.

BGP Default IPV4-Unicast—This is used to set the default as the IP version 4 (IPv4) unicast for BGP
peers on the router.

BGP Default-Metric—This is used to configure the default-metric value for redistributed routes.

Note

If this attribute is set to zero, then the default metric is removed from the device.

Disabling BGP on a Chassis

This section describes the procedure to disable a BGP process running in the device. To disable a BGP
process, proceed as follows:

Step 1

Open the BGP Configuration window. See

for further details.

Step 2

Choose the chassis for which you want to disable BGP from the left side of the window.

Note

You can choose multiple chassis (from the chassis list) which allows you to disable BGP for the
selected chassis.

Step 3

Click on the Disable button.

Note

The Disable button is active only when there is BGP running on the device.