Checkline FH Series User Manual

Page 8

d) The factory calibration is for quick and easy measurement when larger measuring errors are

acceptable. For other calibration methods please refer to section 6.2.

e) For measurement, please use the sensor stand supplied with the gauge. Place the measuring

object on the sensor. Place the target ball on the opposite side. For measuring hollow parts,

place the ball inside the sample. Equipped with a strong permanent magnet, the sensor attracts

the target ball and holds it exactly over its sensor tip. Hold the measuring object in rectangular

position to the sensor and move it smoothly over the sensor. Press OK to store the reading into

memory. Press Function key “Statistics” to view readings and the numerical statistics.

For measuring large-sized sheeting material or large hollow parts, place the senor on the

surface of sample. The target ball is placed on the opposite side near the sensor. Keep the

sensor in rectangular position to the surface and move it across the surface of sample.