Checkline FH Series - Manual (Page 45)

© ElektroPhysik MiniTest 7200 FH / MiniTest 7400 FH 45
permanent signal.
10.5.5 User Preferences
In the User Preferences menu the following settings can be made:
- Language
- Measuring system (metric / imperial)
-
Loudspeaker (ON/OFF).
- Signal Volume (low, high, medium)
- Auto Switch OFF (after 1, 3, 10, 30 minutes, disabled)
- Entry accepted (numeric or alphanumeric entries accepted
(after 0,5, 1, 1,5 or 2 seconds).
-
Modification lock**
** You can assign a password for the Modification lock (pay attention
to upper and lower case so that the modification lock will be
password protected. If you have forgotten the password you can
make a total reset. Please note: a total reset deletes all readings and
settings stored in memory. Please also refer to section 4.4.1.
10.5.6 Gauge Specifications
From Setup Menu use arrow keys to go to “Gauge Specs“. Press OK
to confirm. Now you can view gauge specifications.
For viewing sensor data press function key “Sensor”.
In case of service requests please make available these data for
further reference.