Checkline FH Series - Manual (Page 20)

© ElektroPhysik MiniTest 7200 FH / MiniTest 7400 FH 20
5.4.2 Using the sensor stand
If you are using the sensor stand, position the sample on the sensor tip and keep it in right-angle
position to the sensor. Place the appropriate target ball on the opposite side of object. Make sure
to keep the right-angle position while moving the object continuously over the sensor. For storing
readings, please refer to section 5.5.1.
When measuring small hollow parts such as bottles e.g., put the target ball inside the object and
place the object onto the v-grooved device of sensor stand. Turn the object until the target ball is
centered directly over the sensor tip. Then move the object continuously over the v-groove of
sensor stand. For storing readings, please refer to section 5.5.1.
5.4.3 Delete Readings
Please refer to section 8.2.2 “Delete Single Readings“.
5.5 Storing Readings into Statistics Memory
5.5.1 Data Logging Mode
During measurement, readings can be stored into memory manually or automatically. Data in
memory will be used for statistics.
The following storing options are available:
- Storing the current reading manually or automatically
- Storing the minimum reading (only manually)
- Storing the maximum reading (only manually).
The Data logging mode can be specified in the “Configuration” submenu. Use arrow keys to select
the Data logging mode option and press OK to confirm. You can chose from the following setting
options:
- Curr. reading (Current reading)
- Auto
- Max
- Min
Make your selection and press OK to confirm. If you wish to undo your setting (before OK has
been pressed) press ESC and the gauge will return to the previous menu level.