Checkline FH Series - Manual (Page 58)

© ElektroPhysik MiniTest 7200 FH / MiniTest 7400 FH 58
Target ball: (adjusted ball size) measurement.
“Full memory capacity !” Probable cause:
You have reached maximum
number of storable readings.
You have reached maximum
number of entries in the data
base (MiniTest 7400 only)
Delete readings, batches or
directories in the database which
you do not need any more.
“Memory optimization in
progress”
Message appears briefly on
display.
Automatic procedure. No further
action required.
“Check sensor connection !” Possible cause:
the sensor has been
removed
loose probe connection
damaged cable
defective sensor
Please check the options. If the
sensor is defective, please
change it or contact after sales
service.
“No sensor connected ! “
“Changes not possible !”
Sensor connecting error.
Possible cause:
no sensor connected
loose probe connection
damaged cable
defective sensor
Please check the options. If the
sensor is defective, please
change it or contact after sales
service.
“Sensor failure “” Please contact after-sales
service.
The following errors may be remedied by a total reset (see section 11.1)
-
keyboard failure
- no measuring admitted
- illogical readings
If the gauge cannot be switched off via the ON/OFF button, remove and reinsert batteries.