Welch Allyn Acuity LT Mobile - Installation Guide - Manual (Page 63)

C
59
Install additional APs
If the final system check (described in “Perform a final system operation check” on
page 31) indicates that there are areas of your facility where the network coverage is not
adequate (RSSI is 50 or above), consider installing additional access points (APs). You can
install up to a maximum total of seven APs.
Inadequate network coverage typically occurs in areas where there are too many
obstructions, such as in the following instances:
• Behind elevators
• Behind metal-reinforced walls
• Too many walls between the monitor and the AP
To order additional APs
Contact your Welch Allyn representative:
Toll free USA: 1 800 289 2501
Worldwide: +1 503 530 7500
Note If your system has four to seven APs, you must add an additional UPS to
accommodate the additional PoE power supplies.