Welch Allyn Acuity LT Mobile - Installation Guide - Manual (Page 59)

Installation Guide Appendix B Wireless Acuity LT Central Monitoring System 55
Propaq LTR monitor network name (ESSID)
Check the Propaq LTR monitor network name
1. From the main display, highlight SpO2 and press .
2. Highlight Setup and press to access the Setup menu.
3. Highlight Service and press to access the Service menu.
4. Highlight Radio, then highlight Show Info and press .
The monitor displays the current Net name. The Net name must match the Network
Name on the CPU left side panel label to connect to the wireless Acuity LT System.
5. To exit, highlight Exit and press .
Change the Propaq LTR monitor network name
1. From the main display, highlight SpO2 and press .
2. Highlight Setup and press to access the Setup menu.
3. Highlight Service and press to access the Service menu.
4. Highlight Radio, then highlight Net Name and press .
The monitor displays the list of possible Net Names (scroll to see the entire list):
com.protocol
demo.protocol
com1.protocol
com2.protocol
.. . . .
com18.protocol
The current Net Name is highlighted.
5. To change the Net Name, scroll to highlight the desired Net Name, then
simultaneously press
and (the left and right arrow buttons). The monitor is now
set to the new Net Name.
6. Press to exit the Net Name menu.
To recheck the Net Name, highlight Show Info and press .
Note Changing the patient monitor network name causes the monitor to seek to
connect with any nearby wireless Acuity System network corresponding to the
new name. Do not attempt to change the network name unless you are a
qualified biomedical service engineer or technician.
WARNING When setting the patient monitor network name, make sure that it
matches the network name labeled on the CPU for your wireless Acuity LT
System. If a different network name is set, the monitor could connect to a
different nearby wireless Acuity System. This would result in confusion about
patient monitoring and the location of patient data.