Welch Allyn Acuity LT Mobile - Installation Guide - Manual (Page 60)

56 Appendix B Check or change a patient monitor network name (ESSID) Welch Allyn Wireless Acuity LT Central Monitoring System
Wireless Propaq CS monitor network name (ESSID)
Check the wireless Propaq CS monitor network name
1. From the Main Menu, press SETUP, MORE, MORE, SERVICE, YES, MORE, MORE,
RADIO STATUS.
Change the wireless Propaq CS monitor network name
1. From the Main Menu press SETUP, MORE, MORE, SERVICE, YES, MORE, MORE,
RADIO STATUS, CHANGE NET NAME to access the Change Net Name screen.
The current network name is highlighted. (To exit without changing the network
name, press PREVIOUS MENU or Home.)
2. To change the network name, press NEXT to scroll down and highlight the desired
network name, and then press SELECT.
The monitor displays a confirmation screen asking you to confirm that you want to
change the network name.
NETWORK STATUS
NETWORK
MONITOR
PREVIOUS
MENU
BATTERY: 9.2 VOLTS
FIRMWARE VER:
S24 COUNTRY:
NET NAME:
MONITOR MAC:
MONITOR IP:
AP MAC:
ACUITY IP:
PSICP
RSSI:
ACUITY CONNECTED
V4.57 991001
INTERNATIONAL MODE 0
com8.protocol
12:34:56:78:90:12
192.168.210.201:7711
12:34:56:78:90:12
192.168.210.101:32790
RX: 40 TX: 158
38
Network
Name
Note Changing the patient monitor network name causes the monitor to restart and
seek to connect with any nearby wireless Acuity System network corresponding
to the new name. Do not attempt to change the network name unless you are a
qualified biomedical service engineer or technician.
CHANGE NET NAME
NEXT PREVIOUS
MENU
COM.PROTOCOL
SELECT
DEMO.PROTOCOL
COM1.PROTOCOL
COM2.PROTOCOL
COM3.PROTOCOL
COM4.PROTOCOL
COM5.PROTOCOL
COM6.PROTOCOL
COM7.PROTOCOL
COM8.PROTOCOL