Programming instructions, Maintenance – KMC Controls KMD-1281 User Manual
Page 9
NetSensor Installation and Operation
Revision A
9
Programming instructions
Programming instructions for NetSensors are included in Help
supplied with WinControlXL, BACstage, and TotalControl.
Maintenance
Remove dust as necessary from holes in top and bottom. Clean the
display and motion sensor cover with a soft, damp cloth and mild
soap.
This manual is related to the following products:
See also other documents in the category KMC Controls Sensors:
- BAC-5801 (2 pages)
- CSP-4702 (4 pages)
- CEP-4703 (4 pages)
- HTO-1103 (8 pages)
- CSP-5001 (4 pages)
- CSP-5001 (21 pages)
- BAC-8001 Installation Guide (88 pages)
- BAC-8001 Quick start (2 pages)
- CCC-1001 (4 pages)
- CSC-3000 Series (2 pages)
- BAC-12xx63 Series FlexStat (9 pages)
- FlexStat Operation Guide (46 pages)
- FlexStat Quick Reference Guide (2 pages)
- BAC-12xx36 Series FlexStat (11 pages)
- CSC-2000 Series (4 pages)
- CEP-4000 Series (4 pages)
- BAC-4000 Series (4 pages)
- CTE-5202 (4 pages)
- CTE-5201-16 (4 pages)
- CTE-5100 Series (4 pages)
- CTE–1003 (2 pages)
- CTE–1005 (2 pages)
- CTE-1001 (2 pages)
- CTC-1611 (2 pages)
- CTC-1621 (2 pages)
- KMD-1162 (8 pages)
- KMD-1183 (1 page)
- SAE-1011 (6 pages)
- SAE-1111 (9 pages)
- TPE–1464 Series(2004-2008) (6 pages)
- TPE-1464 Series(2008 and later) (3 pages)
- TPE-1483 Series(2008 and later) (3 pages)
- TPE-1483 Series(2004-2008) (6 pages)
- IEI-1001 (2 pages)
- SAE-1101(NEW Style Board) (5 pages)
- SAE-1101(OLD Style Board w/ LEDs) (8 pages)
- THE-1002 (2 pages)
- THE-1102 (2 pages)
- THE-1105 (2 pages)
- TTE-1001 (2 pages)
- STE-8000 series (4 pages)
- SSE-1000 Series (2 pages)
- STE-1415 (2 pages)
- STE-1411 (2 pages)