Rough-in preparation – KMC Controls KMD-1281 User Manual
Page 6
KMC Controls
Revision A
6
Rough-in preparation
Caution
To prevent mounting screw heads from touching the circuit
board in the NetSensor, use only the mounting screws
supplied by KMC Controls. Using screws other than the
type supplied will damage the NetSensor.
Complete rough-in wiring at each sensor location prior to sensor
installation. This includes the following.
◆
Routing the network cable from the NetSensor to a controller.
◆
If required, installing the appropriate backplate. See
for model numbers.
NetSensor mounting details
RJ-12
cable
Allen
screws
Mounting
base
This manual is related to the following products:
See also other documents in the category KMC Controls Sensors:
- BAC-5801 (2 pages)
- CSP-4702 (4 pages)
- CEP-4703 (4 pages)
- HTO-1103 (8 pages)
- CSP-5001 (4 pages)
- CSP-5001 (21 pages)
- BAC-8001 Installation Guide (88 pages)
- BAC-8001 Quick start (2 pages)
- CCC-1001 (4 pages)
- CSC-3000 Series (2 pages)
- BAC-12xx63 Series FlexStat (9 pages)
- FlexStat Operation Guide (46 pages)
- FlexStat Quick Reference Guide (2 pages)
- BAC-12xx36 Series FlexStat (11 pages)
- CSC-2000 Series (4 pages)
- CEP-4000 Series (4 pages)
- BAC-4000 Series (4 pages)
- CTE-5202 (4 pages)
- CTE-5201-16 (4 pages)
- CTE-5100 Series (4 pages)
- CTE–1003 (2 pages)
- CTE–1005 (2 pages)
- CTE-1001 (2 pages)
- CTC-1611 (2 pages)
- CTC-1621 (2 pages)
- KMD-1162 (8 pages)
- KMD-1183 (1 page)
- SAE-1011 (6 pages)
- SAE-1111 (9 pages)
- TPE–1464 Series(2004-2008) (6 pages)
- TPE-1464 Series(2008 and later) (3 pages)
- TPE-1483 Series(2008 and later) (3 pages)
- TPE-1483 Series(2004-2008) (6 pages)
- IEI-1001 (2 pages)
- SAE-1101(NEW Style Board) (5 pages)
- SAE-1101(OLD Style Board w/ LEDs) (8 pages)
- THE-1002 (2 pages)
- THE-1102 (2 pages)
- THE-1105 (2 pages)
- TTE-1001 (2 pages)
- STE-8000 series (4 pages)
- SSE-1000 Series (2 pages)
- STE-1415 (2 pages)
- STE-1411 (2 pages)