KMC Controls BAC-14xx36 Series FlexStat - Manual (Page 7)

BAC-12xx36/13xx36/14xx36 Series FlexStat 7 Installation Guide, Rev. C
AHU 1H/1C LAYOUT
CSE-1102 Air Differential
Pressure Switch
MEP-5372, MEP-7252, MEP-7552,
or MEP-7852 Actuators
STE-1402 Duct
Sensor, Type III
STE-1416 Duct Averaging
Sensor, Type III
STE-1451 OAT Sensor, Type III
XEE-6311-050 Transformer
See also the
AHU—Additional
Options section
on the last page
for network,
humidification,
and fan speed
options.
XEE-6311-075 or XEE-6311-100 Transformer
REE-3211 or CVR11C-0/LD96200 Multi-Voltage Relays
Output
Terminals
AHU Output
Connections
BACnet
Objects
Analog 9
Optional Outside Air
Damper (OAD/RTD)*
AO9
GND
Ground (for analog
output terminals 7–9)
Analog 8 AO8
Analog 7 AO7
Analog 6 Optional Humidification
Valve (HUM or HUMV)
AO6
GND
Ground (for analog
output terminals 4–6)
Analog 5 AO5
Analog 4 Optional Fan Speed AO4
Relay 3 Heat 1 (W1) BO3
SC 1–3
24 VAC (for relay
terminals 1–3)
Relay 2 Cool 1 (Y1) BO2
Relay 1 Fan 1 (G) BO1
*If optional Outside Air Damper is used,
must also have MAT/OAT inputs.
AHU (Air Handler Unit)—1 Heat and 1 Cool
APPLICATION
DEGREES SCALE: °F
APP:
OPT: 1H/1C
ADDITIONAL SETUP
AIR HANDLER
ADDITIONAL SETUP
DAMPER
FAN
HUMIDITY
OPTIMUM START
SENSORS
Input Terminals AHU Input Connections BACnet Objects
IN9 Opt. Remote CO
2
Sensor* AI9
IN8 AI8
IN7 Opt. Remote Temp. Sensor* AI7
IN4 Opt. Outside Air Temp. (OAT)** AI4
IN3 Opt. Mixed Air Temp. (MAT)** AI3
GND Ground
IN2 Optional FST or DAT* AI2
*Fan Status (FST), Discharge Air Temperature (DAT), and (not shown
on the diagram) remote temp./CO
2
sensors are optional inputs. Set
pull-up resistor switch positions appropriately (see the Input
Connections section).
**When using the optional Outside Air Damper, MAT/OAT inputs must
also be connected.
NOTE: Do not use REE-3211/ CVR11C-0/LD96200
relays with analog outputs! See Output
Connections on page 3.