EFCO S5500 SSG Captured - Manual (Page 30)

EFCO CORPORATION 6/2012 PART NO. Y556 Page 30 of 81
S-5500 SSG and Captured Corner Mullion Installation Instructions
Section V: Glazing Preparation (Captured)
STEP #2 SET AND ATTACH CORNER MULLION GLAZING ADAPTER
A. Apply sealant to the bottom end of the corner mullion glazing adapter as shown in the
inset detail A.
B. Insert the end of the corner mullion glazing adapter as shown in the main detail below.
C. Fill all voids completely and tool the sealant smooth on the bottom end of the corner
mullion glazing adapter.
D. Attach the glazing adapter to the corner mullion with the required fasteners.
E. Cap seal the fastener heads at all fastener penetrations.
SILL AT CAPTURED CORNER
C. Fill all voids completely,
and tool smooth.
A. Apply sealant to the
bottom end of the
corner mullion glazing
adapter as shown.
B. Insert the end of the
adapter behind the
notches in the sills.
D. Attach the glazing
adapter to the corner
mullion with the required
fasteners. Cap seal the
fastener heads with
sealant. Fasteners should
not exceed 2” from the
ends of the adapters and
be spaced at a maximum
of 12” o/c.
CAPTURED
SILL
CORNER
MULLIONS