Dell 3115cn Color Laser Printer - Manual (Page 70)

Protocol Select the check box to enable the protocol.
IKE Use a preshared key for IKE authentication.
Pre-Shared Key Specifies a shared key.
Re-enter Pre-Shared Key Enter the shared key again to confirm it.
IKE SA Lifetime Sets the lifetime for IKE SA from 5 to 28800 minutes.
IPsec SA Lifetime Sets the lifetime for IPsec SA from 5 to 2880 minutes.
DH Group Selects the DH group.
PFS Selects the check box to enable the PFS setting.
Remote peers IPv4 address Specifies the IP address to connect to.
Remote peers IPv6 address Specifies the IP address to connect to.
Non IPsec communication
policy Selects whether or not to communicate with a device which does
not support IPsec.
NOTE: If IPsec is enabled with incorrect settings, you must disable it using the Reset IPsec menu on
the operator panel.
Reset Print Server
Purpose:
To initialize NVRAM (non-volatile RAM) for the network feature and reboot the multifunction printer. You can
also initialize the printer's NVRAM from Reset Defaults in the Printer Settings menu.
Values:
Initialize NIC NVRAM
Memory and restart printer Click the Start button to initialize NVRAM. Network settings will revert to
the factory default settings and reboot the network capability.
Restart Printer Click the Start button to reboot the multifunction printer.
Copy Printer Settings
The Copy Printer Settings menu includes the Copy Printer Settings and Copy Printer Settings Report
pages.
NOTE: You cannot copy the following printer settings:
Copy Defaults
Copy Color Balance
Copy Settings