Dell Brocade Adapters - Manual (Page 248)

220 Brocade Adapters Installation and Reference Manual
53-1002144-01
Network driver parameters
A
Managing VMware driver configuration with cfg
• Following is an example of using the esxcfg-module command to disable message signaled
interrupts (MSI-X).
esxcfg-module -s ”bnad_msix_disable=1” bna
where:
bnad_msix_disableBrocade network adapter message signaled interrupts
1 Disables MSI-X and enables INTx mode instead.
NOTE
MSI-X is enabled in the network driver by default, and must remain enabled for NetQueue to
function. Enabling NetQueue in VMware system also enables MSI-X in the system by default. If
enabling NetQueue, make sure that bnad_msix_disable=1 is not listed in VMware module
parameters because that would disable NetQueue.
• Display current driver configuration settings using the following command:
esxcfg-module -g bna
• Following is an example of using the esxcfg command to set the Jumbo Packet (MTU) size.
First, set the MTU size on a virtual switch using the following command.
esxcfg-vswitch -m
where:
MTU size MTU size (1500-9000 kb)
vSwitch ID Virtual switch identification, such as vSwitch0
Display a list of virtual switches on the host system and their configurations using the following
command.
esxcfg-vswitch -l
Next, create VMkernal interface with the MTU setting.
esxcfg-vmknic -a “VM Kernel” -i -n -m
where:
VM Kernel VMkernal name.
Other NetQueue
Configuration
•
Number of
NetQueues and
filters
•
Heap values
NA NA esxcfg-module
VM Client interface
Refer to “Configuring
NetQueue” on page 221.
Legacy Ethernet
pause NA autoneg: off, on
rx: off, on
tx: off, on ethtool -A command Flow control mechanism for
Ethernet.
TABLE 39 Network driver configuration parameters (continued)
Function Default Value Possible Values Method to Configure Notes