Dell Brocade Adapters - Manual (Page 166)

138 Brocade Adapters Installation and Reference Manual
53-1002144-01
Boot over SAN
4
4. Select one of the following:
• Adapter Settings. Use the Adapter Settings screen to enable BIOS, adapter port speed
(HBAs and Fabric Adapter ports configured in HBA mode only), and discovery of boot LUN
information from the fabric. You can determine adapter N and PWWN. Proceed to
step 5 .
• Boot Device Settings. Use the Device Settings screen to select the boot target and LUN for
booting the host system. Proceed to
step 7 .
5. Select Adapter Settings and press Enter to begin adapter configuration.
A screen similar to the following displays showing the port’s current BIOS version, NWWN,
PWPN, and MAC (CNAs and Fabric Adapter ports configured in CNA mode only).
Table 11 on
page 138 explains options available for BIOS, Port Speed, and Boot LUN settings.
-
TABLE 11 Brocade BIOS Configuration Utility field descriptions
Field Description
BIOS The value of BIOS must be Enable for the selected adapter port to
support boot over SAN. If this setting is set to Disable, the system will
not boot from the Fibre Channel disk drives that are connected to the
selected adapter port.
NOTE: The default setting for all adapter ports is enabled.
BIOS Version Displays the Brocade BIOS boot code version installed on the card.