Dynalco AF-900PC Air/Fuel Ratio Controller - Manual (Page 32)

31
Single or Dual Bank Dual Bank Only
L PRE-CAT O
2
R PRE-CAT O
2
POST-CAT O
2
R EXHST TEMP
BOARD ID
RAW POWER
For MAP Programming
PRE-CAT TEMP L MAP
POST-CAT TEMP R MAP (Optional)
L EXHST TEMP
CJC TEMP For Intake Manifold Temperature
L MANF TEMP
R MANF TEMP
NOTE: 4/20 #3 and 4/20 #4 are not used by the AF900PC.
PRE-CATALYST CONFIGURATION SCREEN
This screen (Fig. 15) is used to set up the left and right bank pre-catalyst system.
The following section describes the function of every parameters located on this
screen. The parameters for the left and right bank are identical so they will be
discussed only once.