Dynalco AF-900PC Air/Fuel Ratio Controller User Manual
Page 28
27
Log Parameter List: The Log Parameter List (Fig. 11) shows the most important
controller parameters being data logged. Disable by clicking the En buttons for any
parameters you do not wish to data log. Enter “0” for the Chart # for any
parameters where an excel chart is not required.
NOTE: Parameters having no numerical value (such as Status) must be
assigned to chart # 0.
NAME shows the parameter name as it appears on the header on the excel
spreadsheet and on the excel charts. The names may be edited if desired.
If you wish to log a parameter not shown:
1. Enter the parameter number and index.
2. Enter the parameter chart #.
3. Enter the parameter name.
The parameter number and index may be found by placing the cursor over the
name of the parameter. The index is the decimal value of the parameter.
NOTE: Enter 255 for the index if the parameter does not have a decimal value.
Flash Memory: This section, shown at the bottom of Fig. 11 of the data log screen,
shows the status of the Onboard Flash Memory. “# Logs Stored” indicates the
number of data logs which have occurred since the last memory reset. “Capacity”
shows the maximum number of data logs required to fill the memory. To “reset”
memory, type “new card” in the Reset box and press enter. The flash memory will
be reset when the next data log occurs. All previously recorded data on the flash
memory will be lost upon reset.