Dynalco AF-900PC Air/Fuel Ratio Controller - Manual (Page 27)

26
DATA LOG SCREEN
This screen (Fig. 11) sets up the data log system and current date/time.
Data log parameters may be modified as follows:
Current Date/Time: The time and date may be changed by deleting the old value
and entering a new value as required.
Data Log Schedule: Up to ten (10) daily data log times or a periodic data log
interval may be used. The unit may also be set up for one (1) periodic interval time
and up to nine (9) daily log times.
To enable periodic mode data logging:
1. Enter the desired data log interval.
2. Select PERIODIC mode from the drop down menu.
3. Click the EN button for that channel.
To enable daily data logging:
1. Enter the desired data log time.
2. Select DAILY mode from the drop down menu.
3. Click the En button on that channel.
NOTE: Data Log may occur as often as once per second.
Data Log Screen
Figure 11