ADS Environmental Services Model 3600 530002 A2 - Manual (Page 55)

4-22 ADS 3600 Flow Monitor O&M Manual
Standard Ultrasonic Mount
The standard ultrasonic mount is the original sensor mounting method, and it is still
the most popular mounting method in use.
You will need the following parts when assembling one standard ultrasonic mount:
l one metal ultrasonic plate,
l one quick release bracket (machine screws included),
l four 6-32
×
1 in. (25 mm) round head machine screws,
l eight 6-32 washers, and
l four 6-32
×
5/16 in. (8 mm) nuts.
You will need the following tools when assembling one standard ultrasonic mount:
l a small slotted screwdriver,
l a small Phillips-head screwdriver, and
l a 5/16 in. (8 mm) nut driver.
Pre-Installation Assembly
l Locate the four countersunk holes in the middle of the ultrasonic plate.
l Slide the top portion of the quick release mechanism off the base and locate the
four countersunk holes.
l Align the holes and secure with the 4-40
×
5/16 in. (3 mm) machine screws.
l Orient the base of the quick release mechanism with the top of the ultrasonic
sensor until the pre-drilled holes line up.
l Insert a 6-32
×
1 in. (25 mm) machine bolt with a 6-32 washer through the
base and the ultrasonic sensor holes. Secure with a 6-32 washer and 5/16 in.
(8 mm) nut.
l Secure the three remaining locations as described in the previous step.