ADS Environmental Services Model 3600 530002 A2 - Manual (Page 54)

Ring, Sensor, and Special Installations 4-21
Required Supplies
Obtain the following supplies before conducting a special installation. You may not
need all of the materials each time you need to do a special installation, but the
materials should be available to prevent any costly delays. Supplies can be ordered
from the ADS corporate office in Huntsville, Alabama. When ordering, specify
QS3600 flow monitor special installation hardware.
Quantity Unit Description ADS Part Number
1 each QS3600 flow monitor QS3600
15 each 11 in. cable tie (28 cm) I05-0003
25 each 4 in. cable tie (10 cm) I05-0001
15 each 8 in. cable tie (20 cm) I05-0002
10 each anchor cable ties I05-0004
as required can Scotchkote
®
(electrical coating) I20-0002
as required roll splicing or stretch tape (130C) I45-0001
15 each 1/4
×
2 1/4 in. anchor bolts (with
7/16 in. nuts)
I01-0002
3 each 3/8

3/16 in.
×
1 in. nut I15-0002
6 each 3/8

3/16 in. washer I55-0001
3 each 3/8

3/16 in.
×
1 in. bolt I01-0001
1 each 3/8
×
2 in. (8
×
50 mm) stud I01-0009
2 each 4-40
×
5/16 in. screw I35-0001
8 each 6-32 washer I55-0002
4 each 6-32
×
1 in. (25 mm) machine
screw
I35-0004
4 each 6-32
×
5/16 in. (8 mm) nut I15-0003
1 each quick release bracket I40-0009
1 each ultrasonic mounting plate I40-0008
as required each surcharge mounting bracket I40-0002
1 each 1/4 in. (6.5 mm) masonry drill bit F35-0018
1 each special predrilled flange (8 ft strip)
(2.5 m)
I40-0007
Note: Values and units that appear in italics are direct conversions only;
these mechanical sizes may not actually exist. These values and units were
converted only to enhance readability.