Great Plains PTO Kits 2-3-Section - Manual (Page 51)

Great Plains Manufacturing, Inc. Table of Contents Index Appendix A - Installation 47
2014-09-10 Table of Contents Index 411-015M
Valve on Mainframe LH
This location applies to kit 401-945A, for models
YP3010HDP, YP3025, YP4010HDP and YP4025.
For other kits/models, see the page director table on
page 43.
Refer to Figure 57
91. Select one new:
411-004L YP30,40 PTO FLOW CONTROL
one new:
806-026C U-BOLT 1/2-13 X 7 1/32 X 8 1/4
and two new:
803-147C NUT HEX NYLOCK 1/2-13
With the valve assembly knob down, and Port LS to
implement left, position the mount plate on the left
mainframe tube, clear of stiffener plates and
gussets. Secure with U-bolt
and nuts .
Continue at “Install Hoses” on page 49.
Valve on Fan Mast
This location applies to kits 401-946A and 401-951A, on
models YP3025A, YP4025A and YP4425A. For other
kits/models, see the page director table on page 43.
Refer to Figure 59
92. Select one new:
401-932L YP24 FAN CONTROL VALVE ASSY
one new:
421-136D YP24 HYD VALVE REAR MNT PLT
and four sets new:
802-390C HHCS 5/16-18X3 1/4 GR5
804-009C WASHER LOCK SPRING 5/16 PLT
803-008C NUT HEX 5/16-18 PLT
With the valve assembly knob down and forward,
position the mount plate, to the right, on the left face
of the fan mast tube, about halfway along the
exposed tube length. Secure with rear mount
plate
, bolts , lock washers and
nuts .
Continue at “Install Hoses” on page 49.
218
211
174
U
D
F
B
L
R
Figure 58:
Mainframe LH Installation
36394
174
218
211
218 211
204
213
207
134
U
D
F
B
L
R
181
Figure 59:
Fan Mast Valve Installation
36396
134
181
204
213
207
181 204 213
207