Check hydraulics, Check oil level, Inspect hoses and fittings – Great Plains PTO Kits 2-3-Section User Manual
Page 15: Check oil level inspect hoses and fittings, 21 a
Great Plains Manufacturing, Inc.
PTO Operation
11
2014-09-10
411-015M
Check Hydraulics
Check Oil Level
Refer to Figure 7
1.
Verify that the planter is level front to back and side
to side.
2.
Inspect the sight gauge
on the pump system
reservoir. The oil level
must be aligned with the
center border of the OIL FILL LINE decal
(858-029C).
Hot Surface and Hot Fluid Hazards:
Assess the reservoir temperature before adjusting oil level.
Draining excess hot oil could result in a severe burn. If the
PTO has been operated recently, the oil temperature could be
as high as 180
°F (82°C).
3.
Add or drain oil as needed to obtain the correct
amount. Some adjustment is normally required with
a new system, or after a filter change.
Note: The fill level dimension from reservoir bottom is:
10.73 inches (27.3 cm)
If the 858-029C decal requires replacement, adjust
the top edge of the center border line to this height.
Inspect Hoses and Fittings
4.
Check that all hydraulic fittings are tight and dry.
Inspect all hoses for damage, wear and fatigue.
Because the PTO pump system is closed, any
visible fluid may be an indication of a leak.
858-029C
CAPACITY = 13.5 U.S. GALS
USE ANY HIGH QUALITY MINERAL BASED
HYDRAULIC FLUID WITH A VISCOSITY RATING
OF 10W-30. OIL MUST BE CLEAN AND FREE
FROM DIRT OR CONTAMINANT PARTICLES TO
PREVENT DAMAGE TO PUMP AND MOTOR.
REPLACE FILTER ELEMENT AFTER EVERY
150 OPERATING HOURS OR 2 YEARS SERVICE.
LEVEL TOOLBAR BEFORE CHEKING OIL LEVEL
OIL FILL LINE
818-240C Rev. A
To avoid Injury or
Machine Damage:
·Operate only with
1000 rpm PTO
CAUTION
858-004C
Read Owner’s Manual BEFORE operating machine.
Keep tractor at IDLING SPEED and slowly engage PTO
to prevent damage to Hydraulic Motor
Keep Radiator clean and free of foreign matter to
prevent overheating.
Do NOT operate with hydraulic oil at or above 180°F.
HOT FLUID HAZARD
WARNING
858-030C
All driveline guards, tractor
and equipment shields in place
PTO pump assembly securely
attached with torque arm and clamp
bolts properly torqued
ROTATING DRIVELINE -
CONTACT CAN CAUSE DEATH
KEEP AWAY!
DO NOT OPERATE WITHOUT-
DANGER
2
1
a
Figure 7:
Check Oil Level
34847
1
2
a