Great Plains PTO Kits 2-3-Section - Manual (Page 47)

Great Plains Manufacturing, Inc. Table of Contents Index Appendix A - Installation 43
2014-09-10 Table of Contents Index 411-015M
Install Flow Control Valve
When powered by PTO, the primary control of fan speed
is the flow control valve, normally located near the fan or
fans.
Determine Control Location
Control valve location varies principally by planter
mainframe structure and fan location. There are eight
locations for the presently available kits. Continue on the
page for your kit, per the page director table below.
Flow Control Install Page
Kit Valve Location Go To
401-934A Arch Frame Cross Tube page 44
401-935A Fan Manifold page 45
401-936A Arch Frame Cross Tube page 44
401-937A Fan Manifold page 45
401-938A Rear Walkboard page 45
401-939A 3-Point Hitch page 46
401-940A 3-Point Hitch page 46
401-941A 3-Point Hitch page 46
401-942A 3-Point Hitch page 46
401-943A Center Walkboard page 46
401-944A Center Walkboard page 46
401-945A Mainframe LH page 47
401-946A Fan Mast page 47
401-951A Fan Mast page 47
411-014A Center Walkboard page 46
411-138A Cart Strut page 48
411-147A Rear Walkboard page 45
Figure 52:
Flow Control Valve Installed
at Fan Manifold
34843