Wheatheart X160 Series - Manual (Page 82)

3. A SSEMBLY W HEATHEART - G RAIN A UGERS
X160-85, X160-105, X160-125
82 30875 R0
3.10. CONNECT THE PTO DRIVELINE
1. Clean dirt off of stub shaft (20605) ends before assembly.
2. Install the stub shaft on the PTO driveline using a 3/8” x 1-3/4” square key
(17066) and a 3/8” x 2-1/2” coil roll pin (18546). Tighten the 3/8” x 3/8” set
screw on the PTO driveline.
Figure 3.36 Connecting the Stub Shaft to the PTO Driveline
3. Insert the splined end of the PTO stub shaft into the “forward” speed reducer
gear box position.
4. Slide the PTO transport saddle (18537) through the support strap on the boot
and rest the PTO driveline in it.
Figure 3.37 PTO Parts and Installation
FORWARD
REVERSE