Wheatheart X160 Series - Manual (Page 142)

9. A PPENDIX W HEATHEART - G RAIN A UGERS
X160-85, X160-105, X160-125
142 30875 R0
9.3. REMOTE TRANSMITTER INSTRUCTIONS
Figure 9.2 Remote Transmitter
RESET
button activates the receiver and the keypad function buttons. This
button is green with no markings and functions as the ON button.
STOP
button switches off the receiver and the keypad function buttons. This
button is red with an exclamation point and functions as the OFF button.
DIRECTIONAL
buttons move the hopper in opposite directions as desired.
These buttons are yellow with arrow symbols.
L.E.D.
pattern significance:
• Blinks when the transmitter and receiver are active.
• On when a transmitter button is pressed.
• Pulses while transmitting when battery is low.
9.3.1. P
ROGRAMMING
R
ECEIVERS WITH
S
ERIAL
N
UMBERS
293996
AND
H
IGHER
T O R EGISTER ONE T RANSMITTER TO A R ECEIVER :
Important:
Registering more than one remote transmitter to a single Power Swing is
acceptable but registering one remote transmitter to multiple Power Swings is
not recommended.
Note:
To clear all codes from transmitter, hold down the red stop button for at least 45
seconds.
NOTICE
The transmitter automatically transmits a STOP signal after
30 minutes; this de-activates the receiver and the
transmitter keypad.